Hello Guest My Account
View Cart

Customize Your ClearView

This page contains 'stock' configuration images of ClearView Aquarium Lids.  You can use the images on this page to markup the specifications for cutouts on your very own ClearView Lid.  More organization, instructions, and content will be added to this page in the near future.


 ClearView Tsunami Lid Sections are included on this page as well.  The red box within a respective section is intended to show you the area in which customizations must be included.  Customizations cannot go outside of this box without requiring the section to be widened to accommodate the necessary cutout.  The frame width on the Tsunami can be widened, but the cutout requiring the extension must be at least 5" away from the nearest Tsunami Interlock joint. 


 The lid sections all have a channel that is used to secure the mesh with spline.  In order for this channel to seamlessly pass the spline onto a connecting section, it must always enter and exit the given section at a very precise point.   Changing this location on one section would require changing it on at least 2 other sections as well since they all connect on both sides.  Not only would this require a lot of redesigning; it would also greatly reduce the flexibility of the modular design as those modified sections would be incompatible with the Tsunami standard.  


Up to 1 7/8" depth to the cutout on Long Side Sections is possible without needing to reshape the spline channel and inner frame to support a larger cutout.

Up to 3/4" depth to the cutout on Side Sections is possible without needing to reshape the spline channel and inner frame to support a larger cutout.